The MICRO waterproof sink plate 2.0 comes with a silicone ring, and the Micr USB waterproof socket varies in specifications and performance. Currently, most USB sockets have a protective function, which is to use a timing module to prevent the device's battery from overcharging and repeatedly charging, in order to extend battery life. In addition, for timing selection, partition management is required to improve charging efficiency and plug structure design. The Micro USB standard supports the current OTG function of USB, which allows for direct data transfer between portable devices without a host (such as a personal computer). It is compatible with USB 1.1 (low speed: 1.5Mb/s, full speed: 12Mb/s) and USB 2.0 (high speed: 480Mb/s), while providing data transfer and charging, making it particularly suitable for high-speed (HS) or higher data transfer rates, It is a choice for connecting small devices such as mobile phones, PDAs, digital cameras, digital camcorders, and portable digital players. At the same time, it can also provide convenience for the car, only requiring a USB car charger and a MICRO USB data cable for emergency phone charging. And in high-end cars, there is a 5V output interface directly connected to a MICRO USB cable to charge the phone. MICRO USB is versatile and suitable for convenience. Our company's product supports IPX67 waterproof grade. It is achieved through the process of using 5Pin terminal tail integrated adhesive injection, and adding waterproof rubber rings on the interface section to achieve IPX67 waterproof grade. The product in the picture is a large photo taken by our company. The micro USB base is fixed by welding with a plug-in board. Some external dimensions of the BF waterproof type of the micro USB base are: the main length is 5.0mm, the interface width is 4.0mm (including the thickness of the shell adhesive), and the pin width is 0.8mm, The lateral spacing between the two sides of the pins is 7mm. In terms of electrical performance, the product supports excessive current charging. In terms of material used in the product: the inner layer of the hardware is a high-strength stainless steel shell with a thickness of 0.3mm, and the outer layer of hardware has a thickness of 0.25mm. The plastic body is environmentally friendly and high-temperature resistant plastic. At present, the waterproof micro USB motherboard sinking type has been mass-produced. If you need a sample of the IPX67 plug-in board fixed on the waterproof micro USB motherboard, you can contact our company!