The type c6p mother seat belongs to the vertical plug-in type c mother seat series. The interface is a C-shaped or elliptical interface. The manufacturing method is made by riveting the hardware shell, which contains terminals. There are small buckles on the back end to secure the hardware shell and terminals, preventing them from falling out from the inside. There are two pins at the bottom that are welded to the PCB board during welding, and there are 6 pin pins at the tail that are welded to the PCB board. There is small plastic at the tail end, which plays a solid role in welding as a whole. The interface of type C motherboard is smaller than that of type A and type B, reducing the interface area and making it suitable for application in thin volume equipment products. Supports forward and backward blind insertion, with the same front and back design for the interface of type C, thus supporting forward and backward pluggable. The product supports charging function, does not support data transmission, and supports bidirectional power supply. It is possible to change the direction of power transmission, either to charge oneself or to charge external devices. The product uses materials, hardware shell: high-strength stainless steel, plastic body: environmentally friendly and high-temperature resistant LCP plastic, pins: high conductivity copper. It can withstand repeated plugging and unplugging for over ten thousand times in terms of wear resistance life. The product is currently widely used in various electronic products such as computers, smartphones, tablets, peripheral accessories, storage hard drives, etc.