Short body USB motherboard AF11.5 with a length of 6.0H and a single straight edge with a sheath. The front two legs of the white tape shielding cover belong to the charging head dedicated USB motherboard, with a main body length of 11.5mm. It is one of the short body USB motherboards, and the packaging specification is DIP welding of the front two legs of the plug-in board. The pin number is 4Pin, the material is copper plated gold, the plastic terminal is reverse, and the main body height (including plastic) is 6.0H. The interface adopts a single rolled edge (the inner side of the sheath adopts a straight edge process), The sheath material is made of environmentally friendly and high-temperature resistant LCP plastic. This USB base is generally used on charging heads. The sheath has an insulation and shielding effect, and the USB interface can connect multiple different devices. In the past, the serial and parallel ports could only connect to one device, so when switching from one device to another, it had to be turned off. USB saves users these troubles, in addition to being able to connect multiple devices in series, USB also supports hot swapping.

In terms of software, USB designed drivers and application software can automatically start without the need for users to do more operations. Fast enough speed performance is one of the outstanding characteristics of USB technology. The maximum transmission rate of the USB interface can reach 12Mbps, which is 100 times faster than the serial port and more than ten times faster than the parallel port. At present, our company has mass-produced the reverse short body USB motherboard AF11.5 with a 6.0H single rolled edge and protective cover, and the front two legs of the white tape shielding cover. If you need relevant samples, you can directly contact our company!